Siemens C60 & Variants

When dismantling any phone, great care should be taken to ensure that no damage is caused to any of the parts.  Rough handling may result in severe damage of many parts, and if proper anti-static procedures are not followed, electrostatic damage may result in any electronic component.

Before commencing, it is recommended that the correct tools are purchased for the job in hand - at the very least, a Torx T5 screwdriver will be required.  However, the T5 is extremely difficult to get hold of, so you may have to manage with a slightly worn T6 instead.  If you do use a T6, be very careful not to damage the screw heads.

Step 1.    Remove the battery cover.

Step 2.  Remove the battery.

Step 3.  Remove the SIM card.

Step 4.  Remove the front fascia.

Step 5.  Remove the key mat.

Step 6.  Remove the six Torx T6 screws.

Step 7.  Separate the user interface module and screen assembly from the main board.

Step 8.  Separate the main board from the chassis.

Step 9.  Remove the vibra motor and microphone.

Step 10.  Now you should have all the pieces as shown below.

All images on this page are © UselessInfo